Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
71 Posts
I had the same problem on mine. Check and make sure the excess blinker wire isn't getting wedged in there. I had to stretch it out and tape it lengthwise down the tail. Also make sure the wires leading up the tail to the break light are in good and not rubbing. Lastly make sure that the rear side up by the break light is in good and even. It took me a few tries. And even when I got it all together it took a little squeezing and lining up. Take your time and make sure all the clips are in good. I had to do one of the pop clips under the seat several times before it wouldn't pop out on its own.

Worst case, call Hotbodies. I had to call their support guy because I had two different colored blinkers, and they were very helpfull and responsive.

Good Luck.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top