Yamaha R6 Forum: YZF-R6 Forums banner

1 - 12 of 12 Posts

·
I stall my R6
Joined
·
148 Posts
Discussion Starter · #1 ·
Ok, I searched and found the best way to take them off is to use a razor and they come off with no problem. My question is one of my new grips has a smaller opening then the other. Is that normal? Never installed a new set of grips nor taken a set off. Just wanted to make sure before I cut mine off.

Thx for any help.
 

·
Just Burnin Time
Joined
·
2,219 Posts
cut that shit off, way faster and you arent going to re use them, or if you are, do what CashMoney says... The bigger one goes on the throttle tube, the little one goes on the left clip on.
 

·
I stall my R6
Joined
·
148 Posts
Discussion Starter · #4 ·
Thank you will try to pry them off first. If it takes too long will just cut them off.
 

·
R Sexiness
Joined
·
1,139 Posts
i used hairspray when i had to change a grip and it didnt stick so great. i used some gorilla glue then and it aint budging
this works also haha
 

·
I stall my R6
Joined
·
148 Posts
Discussion Starter · #9 ·
Got some grip glue for 1.99. The guy at the shop said hairspray will work but spray paint works better.
 

·
Just Burnin Time
Joined
·
2,219 Posts
i used hairspray when i had to change a grip and it didnt stick so great. i used some gorilla glue then and it aint budging
lol... you werent f.ucking around were you!!

I just use it as an excuse to go bug my hot little neighbors... :sing
 
1 - 12 of 12 Posts
Top