[Justin-Solomon]

For this next trick, I will be installing Gilles Fully Adjustable rearsets (complete with rear brake light, and gp shifting) onto a busted up '04 R6.

 

[Justin-Solomon]

Tools Needed:
New Rearsets,

A busted up bike to put the rearsets on,

Every metric allen wrench possible, pliers, a knife, a screw driver

and beer.

 

[Justin-Solomon]

Take off the Stock brakepedal by unscrewing the two holding it to the frame.

 

[Justin-Solomon]

Flip it over so you can see the rear brake light switch, and the brake cylinder.

straighten the brake light switch split-pin with your pliers, pull it out, then pull out the retaining pin that was held in place with the split pin (this is a picture of the whole pin/split pin area before it's been taken out.)

 

[Justin-Solomon]

Unbolt the brakeswitch, and the cylinder from the back of the stock brakepedal.

 

[Justin-Solomon]

Hook the spring up to the back of the new brakepedal, and the brakelight switch.

 

[Justin-Solomon]

Bolt the brake cylinder onto the new brakepedal, then bolt the new brakepedal back onto your frame.