Yamaha R6 Forum: YZF-R6 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I know this isn't the place to do it but honestly i trust you guys here at the R6 forums more than the ninja 250 ones. I bought my girlfriend a Ninja 250 and yesterday installed her fend eliminator and integrated tail. Everything works but the turnsignals (front and back) just come on and don't blink. I'm 100% sure i've made a mistake somewhere but i'm not sure where to start looking. Any help would be great, thanks in advance guys.
 

·
Registered
Joined
·
1,797 Posts
Not familiar with the Ninja 250...but is there a need to upgrade the relay?
 

·
Premium Member
Joined
·
4,922 Posts
definitely in error in your part since the signals stay on.

try this, i found it over the internet

"for some reason the wiring order is diferent in some regions.
& that the Wire from the Light, that connects to the OEM from the bike, has 3 pins. & the BLACK BLUE YELLOW... needs to be swapped with the BLue and yellow, and then it should work fine.."

try it out i guess
 
1 - 3 of 3 Posts
Top