Yamaha R6 Forum: YZF-R6 Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I ordered an integrated tail light for my 02 R6. the light came with the stock wiring harness that plugs in under the seat and two extra wires, yellow and blue. The extra wires are for the turn signals in the tail lights( left and right). My problem is that when i put on my left turn signal, the left side of the tail blinks yellow AND the right side blinks red. It's suppose to just blink yellow on the side that I'm signaling and the other side should be blank right? It's the same problem when I put on the right signal ( the left side blinks red then)...... The front signals are working fine and everything else seems normal..... any suggestions??? thanks
 

·
Registered
Joined
·
313 Posts
It should not blink the red side. I agree with ^^ See if you can exchange it.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #4
I was hoping someone would suggest something besides returning it. I can't return it. What about a relay adapter? Anyone think that could be the problem. My friend had a problem with the lights blinking way to fast and that slowed it down.
 

·
Registered
Joined
·
313 Posts
I was hoping someone would suggest something besides returning it. I can't return it. What about a relay adapter? Anyone think that could be the problem. My friend had a problem with the lights blinking way to fast and that slowed it down.
That is correct. It will slow the blinking down. Thats not going to stop the wrong/red side from blinking.
 
1 - 5 of 5 Posts
Top