I'll give you a little help with the install because the directions tell you the wrong thing. When taking the stock can off you have to disconnect the ex-up valve cables. The directions tell you to just tuck them away. I think that is stupid. So, what you are gonna want to do after you take the stock pipe off, you need to remove the ex-up valve motor. It is infront of the rear shock. It is only two bolts. Unplug the connector, and remove the box. Disconnect the cables from the box and re-install it the same way you un-installed it. Make sure you reconnect the electrical because you will get an error code/check engine light if you dont. Now you don't have any cable hanging down. Good luck and congrats again.