Yamaha R6 Forum: YZF-R6 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
458 Posts
Discussion Starter #1
hey guys I was putting in the flushmounts today and I went to go take out a bolt on the lower fairing however it was already out. and seeing as how this the first time I have taken it apart I am assuming it was either never there or vibrated out. its the left side on the bottom next to where yamaha letters are. is it cool to ride without it for a lil bit until I can get a replacement? also anyone know where I can get one??
also I sent my rearsets exhaust etc etc to get powder coated. that little cotter pin that connects the master cylinder to the brake switch can I reuse it or should I just get a new one
 

·
Registered
Joined
·
458 Posts
Discussion Starter #2
:boob
 

·
I heart my R6
Joined
·
464 Posts
I had missing bolts too when i picked up my bike at the dealership..

Im assuming it was the lousy mechanics who prep the bike to ride befor they let the buyer take it home who lost it..If nothing is too loose without it, i wouldnt sweat it and just try to get 1 from the dealership when you have time

Also the cotter pin can always be re-used if its not to old/damaged
 

·
Registered
Joined
·
458 Posts
Discussion Starter #4
cool thanks
 
1 - 4 of 4 Posts
Top