Yamaha R6 Forum: YZF-R6 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I am install the proton flush mounts and i cut the stock turn signals off but now im unsure which wires to connect.

Coming out of the proton turn signals i have a red, black, orange and yellow wires.

Coming out of the bike i have a black, blue, and brown wire.

I know the two blacks get connected and i know how the orange/yellow combo works. But im unsure which wire coming out of bike is the power wire (blue or brown).

Any suggestions?

2007 R6
 

·
08 in the crate
Joined
·
344 Posts
I believe it was blue that is the signal. You can always touch it and test it. If you are wrong then no harm done. It will either be running lights are signals... Best advice to anyone that owns a bike is to buy a volt meter... You can test all kinds of things to see if they are right. You can troubleshoot with them as well by following the guides in the owners manual. Best money you can spend on the bike... T
 
1 - 4 of 4 Posts
Top