Yamaha R6 Forum: YZF-R6 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
For the longest time i couldn't get my bike to start.

Things I did:
New fuel pump
new spark plugs
new voltage regulator
new battery
new engine oil
New air filter (k and N)
cleaned tips sensor

what worked below from another thread, put it here since its the right place


Ok guys cleaned the tps sensor, and then unplugged the power comander III and plugged back in like factory and she started right back up like nothing was wrong, code went away and she idled like a champ. Rode to cycle gear with my girl to buy her a helmet, then hopped on the free way, bike would only go up to 8k rpm and then at like 80 she just shut down, so pulled over and started it again and a huge plume of white smoke came out so i shut it down and called a buddy, what do i do? it does have a shorty exhaust and then a k and n filter
 

·
Just lean harder...
Joined
·
888 Posts
I have personally had a PCIII fail, and have seen others fail on bikes. They usually cause a no start when they go bad.

What code did it throw?
 

·
Registered
Joined
·
21 Posts
Discussion Starter · #3 ·
it was a code 46 and ya the bike wouldn't start for shit with it installed and as soon as i connected bike to factory it started right up no issues
 
1 - 3 of 3 Posts
Top