Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

· LEAN
Joined
·
11 Posts
Discussion Starter · #1 ·
Since I bought my used 2003 R6 the shift lever has been set really high. When i went to adjust it, it started catching on the kickstand spring when I downshifted (I think the lever is bent). So I bent it back out a little bit, and I took the rubber sleeve off the kickstand to give it that extra 1/8" of clearance. Is there any reason removing that sleeve is a bad idea?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top