Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,144 Posts
to really know, you'd have to measure the width of the pivot point to see if it would fit and also make sure the hole the shaft goes thru are the same sizes. If you have access to both model years, measure them to see if it is even feasible first. I doubt it since the 03+ were completely redesigned from the ground up using a different rocess to make the frame and swingarm (control filled) so I bet the dimensions are off just enough to make it not work. But I could be wrong and I often am!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top