Yamaha R6 Forum: YZF-R6 Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
HI,

I have a project bike that I would like to run a 180 series tire on. The R6 swingarm seems like the perfect match. What I need to know before buying one is the width of the swingarm where it mounts to the frame. I would also like to get a measurement of the overall length of the swingarm from the centerline of the front bearings to the centerline of the rear axle. I would like results form both 99-02 models and 03 models. Thanks in advance for the help.



Paul
 

·
Registered
Joined
·
831 Posts
I have read through the 03 shop manual. It does not show the actual measurements of the parts. All it shows is the toruque specs. :roll:

So I am not sure of the measurements. Does anone have a swing arm off of the bike that can be measured?
 
1 - 2 of 2 Posts
Top