Yamaha R6 Forum: YZF-R6 Forums banner

1 - 3 of 3 Posts

·
Focus
Joined
·
728 Posts
Discussion Starter · #1 ·
Hey everyone, my question is can I over tighten the center bolt on my triple tree clamp? I do not have a torque wrench to measure. Plus I think my head bearings are bad, and I've read that some people just tighten it up to help. Any advise is appreciated.

Thanks.
 

·
Registered
Joined
·
30 Posts
i was told that over tighting it could be bad. under the triple tree plate there is another nut that is the one to tighten if it is loose inside the neck.
 
1 - 3 of 3 Posts
Top