Yamaha R6 Forum: YZF-R6 Forums banner
Cancel

Unkwown fuse need identification

177 Views 2 Replies 2 Participants Last post by  Ifixit32, 
I
So i have recently purchased a 2000 r6. It did not run when purchased. Fixed grounds in main harness. Now it runs gauges wont turn on. It has a solo 20amp fuse next to main fuse box. Cannot even find it on supplement wiring diagram. It keeps blowing is that for turn signal and lighting. Would that be the possible issue with instruments not powering up. Blown fuse is removed and cover open on right side of pic.
Automotive tire Bicycle tire Motor vehicle Bicycle handlebar Automotive lighting
See less See more
Reply
Save
Like
1 - 2 of 3 Posts
I
Intuit said:
The main fuse is usually equal to or just below the combined value of all the fuses that run behind it. If that is the MAIN fuse, it's possible that whoever installed a replacement, installed the wrong one.

Someone with a 1st Generation bike (or/and manual) can provide more detail. Often times the fuses will be identified on the underside of the lid for the fuse box.
Click to expand...
Have manual and supplement finally traced out complete had shorted signal wire in tail piece now gauges and headlights illuminated.
Reply
Save
Like
  • Like
Reactions: 2
1 - 2 of 3 Posts
Yamaha R6 Forum: YZF-R6 Forums
A forum community dedicated to Yamaha R6 motorcycle owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Discussions Bike Parts For Sale Appearance and Exterior Mods Garage / Mechanical Help Exhaust and fuel delivery
Top