Yamaha R6 Forum: YZF-R6 Forums banner

1 - 5 of 5 Posts

·
Point and Shoot
Joined
·
13 Posts
Discussion Starter · #1 ·
So I'm trying to replace my right side (break side) foot peg from my vortex resets (newer model). I can't separate the foot peg from the bearing. I hammered the shit out of it with no luck. The peg is just worn from a small low side, just replacing it to spend contingency and help prevent my boots from getting worn from the sharp edges. I put it back on the bike, but I'd really like to get the new peg put on.

Any thoughts?

Thanks guys!
 

·
pin it to win it
Joined
·
8,080 Posts
Yup try heat, a propane torch
 

·
Cant quit my R6
Joined
·
454 Posts
anyone have a trick for this? not my r6, but on my cbr. odd how its seized up, just wanna swap the peg and bearing. one set was fine, this set..not so much.
 
1 - 5 of 5 Posts
Top