Yamaha R6 Forum: YZF-R6 Forums banner
1 - 1 of 1 Posts

· Registered
285 Posts
Discussion Starter · #1 ·
the full yosh system came in along with the PCIII and the K&N. PCIII and filter went in flawlessly, and im ready to put the system on. i get the first three flanges torqued down, and on the last one, didnt even get close to torque spec yet, this happens.

customer service from yosh was very good and I should have a new one here monday.

minor setback i suppose. when looking closely at the location of the break, there is clearly and airbubble, or was.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.