Yamaha R6 Forum: YZF-R6 Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
After adjusting the valve clearance of my track bike I'm putting it back together.. all went well except I end up with a connector unconnected. The inside of the connector is quite clean so I suspect it used to be connected before I disassembled the bike.

It's this blue connector that is coming from the ignition coil harness:



Thanks!
 

·
UR B-hind Da 8 Ball
Joined
·
6,241 Posts
I can't figure out what that 6 wire plug is in the 2nd picture, but it is not the AIS. The AIS solenoid only has two wires (a Red/White and a Red/Brown wire).
 

·
UR B-hind Da 8 Ball
Joined
·
6,241 Posts
Why do you still have the hoses on your valve cover, if the AIS is removed?
 
1 - 8 of 8 Posts
Top