Yamaha R6 Forum: YZF-R6 Forums banner

1 - 3 of 3 Posts

·
Now you see me...
Joined
·
1,275 Posts
Discussion Starter #1 (Edited)
I just installed it and have a question.
I got my rpm source from the crank sensor, with a default setting of 4 cylinders, it reports 64000 rpms at idle. I put 100 for number of cylinders and the rpms seem to be almost right on, am i doing something wrong? is there a better way to get an rpm signal for this?

also my throttle position sensor value only goes to 95% open at WOT, and i have the YEC ECU? :dunce:
 

·
Now you see me...
Joined
·
1,275 Posts
Discussion Starter #2
bump, i think i know why my throttle only goes to 95%, i increased my idle by .05% lol
 

·
Only Jealous Ones Envy
Joined
·
848 Posts
Hey did you figure this out? I'm going to install a Zeitronix this week on an R6 with the YEC ecu also. Any tips?
 
1 - 3 of 3 Posts
Top