[Swookie]

Hello, to begin with i bought myself an R6 2005 with some electrical problems. When i bought it there were some error codes on the dash 20 and 30. I rewired some of the wires because they were hard as rock and breaking everywhere plus current rectifier connector was melted down. As i said i rewired everything, connected everything was ready to start but 3 error codes were came up on the dash the same 20, 30 and 11. What seems the problem as i checked every wire from top to bottom i rewired some of them, checked the error code 30 lean angle sensor, changed it to new one but still same error code 30. Any help? Ohh and also if that helps when i try to start the bike i press starter button, starter relay clicks and check engine light comes up and the motor won't turn like it seems as a dead battery but i double checked that the battery is new and the voltage is normal.

 

[03r6guy]

Hello, to begin with i bought myself an R6 2005 with some electrical problems. When i bought it there were some error codes on the dash 20 and 30. I rewired some of the wires because they were hard as rock and breaking everywhere plus current rectifier connector was melted down. As i said i rewired everything, connected everything was ready to start but 3 error codes were came up on the dash the same 20, 30 and 11. What seems the problem as i checked every wire from top to bottom i rewired some of them, checked the error code 30 lean angle sensor, changed it to new one but still same error code 30. Any help? Ohh and also if that helps when i try to start the bike i press starter button, starter relay clicks and check engine light comes up and the motor won't turn like it seems as a dead battery but i double checked that the battery is new and the voltage is normal.

If it was wrecked or dropped the angle sensor can get stuck in trip mode, try tapping it with a hammer. Another thing to check is the kill switch mine broke internally but looked fine from outside. I haven’t looked the codes up so I’m just going off what I know from my experience.

 

[Swookie]

If it was wrecked or dropped the angle sensor can get stuck in trip mode, try tapping it with a hammer. Another thing to check is the kill switch mine broke internally but looked fine from outside. I haven’t looked the codes up so I’m just going off what I know from my experience.

Yeah it was wrecked before i bought it and i put another lean angle sensor from my friends R6 which works perfectly. i put his lean sensor on my R6 but still there is that error code 30

 

[03r6guy]

Yeah it was wrecked before i bought it and i put another lean angle sensor from my friends R6 which works perfectly. i put his lean sensor on my R6 but still there is that error code 30

You can try to clear the codes to narrow down which ones come back.. codes could be left from crash and possibly have you looking in wrong place.

once you get into the diagnostic mode, scroll to code 62. then flip the kill switch off to on to back off. or visa versa. that will clear the stored codes.
*note, code 61 is the history and shows you all the stored fault codes (if any).

 

[Swookie]

You can try to clear the codes to narrow down which ones come back.. codes could be left from crash and possibly have you looking in wrong place.

once you get into the diagnostic mode, scroll to code 62. then flip the kill switch off to on to back off. or visa versa. that will clear the stored codes.
*note, code 61 is the history and shows you all the stored fault codes (if any).

I did it with diag mode cleared everything and 11 20 30 comes back